TEL +49 (0) 7034 31000    |    (UTC+1)   |    Contacts

We have a solution for
problems with costs on casings
by means of protective coatings!

Image not available
Image not available
Slider

Scope of application:

Centrifugal pumps
Spiral pumps
Vertical inline pumps
Axial split case pumps
Sewage pumps
Submersible pumps
Seawater pumps
Cellular wheel sluices
Rubber semi-shells

Downloads:

KSB Pumps Test Winner

The elastomeric MetaLine coating technology is the big winner of the "KSB Pumps (Germany) coating test". In comparison with about 25 international competitors, our energy absorbing material process has established itself with an up to 35 (!) times higher wear resistance!

As the only (!) synthetic coating at all, MetaLine has been classified by KSB as "... a functional cavitation protection ..."! The erosion resistance was even rated twice as high as KSB’s special alloy "Noridur"!

More information

 

 

METALINE SERIES 700

MetaLine Series 700 coatings optimize pump efficiency owing to their very smooth, flow-optimized surfaces. Efficiency increases of more than 3% are even possible with new housings. Service life extension (wear protection optimization) compared to FE materials amounts up to 500%, compared with NFE materials (stainless steel) up to 150%! Basically, the coating serves as a wear layer to protect the original material and especially its static behavior. This wear layer may be renewed if needed for a low cost. However the housing's original strength and geometry remains fully intact.

A special form of cost optimization is the repair of pump half-shells made of rubber. Here, with minimal effort, existing change parts can be fully regenerated again. The cost savings compared to new parts procurement are significant.

 

Product details

Please publish modules in offcanvas position.